Walrus Audio Canvas Re-Amp - Passive Re-Amp Studio Tool
Adding another tool to the musical paint pallet, Walrus Audio is creating another way to design your tone with the Canvas Passive Re-Amp. The Re-Amp is a studio tool designed to send recorded guitar, drums, or other instrument tracks from your recording session through pedals and effects, or different amp combinations. The Re-Amp makes it’s appearance to facilitate all-new ways to experiment with your songs.
- Passive Studio Re-Amp box
- Send previously recorded tracks through guitar pedals or different amp combinations.
- Record your dry tracks first then re-amp later.
- Try pedal- or amp-combinations on dry guitar tracks, drums, vocals or other instruments.
- Explore new ways to experiment with your songs.
- Rediscover the joy and creativeness of using outboard gear during your DAW sessions.
- Flat frequency response from 20 Hz to 20 kHz
- Custom wound transformer that converts the impedance of your signal to work with guitar pedals and
amplifiers.
- Converts 1⁄4” balanced or XLR input from your DAW/Interface to unbalanced 1⁄4” output to pedals or
amps.
- Volume knob to control the level of the re-amp signal being sent back into your pedalboard/amp.
- Ground lift for reducing hum if present on XLR input.
- Phase Inversion switch for phase cancellation when needed.
- High-pass filter to reduce low frequency when needed
- Passive design, no power-supply required
- Pedalboard-friendly format
- Designed and assembled in USA
